Cabinetry
Generic frame components 201
Door face components 202
Door components 203
Door components 204
Door components 205
Door components 206
Door components 207
Door components 208
Door components 209
Door components 210
Door components 211
Door components 212
Door components 213
Door components 214
Door components 215
2 drawers below the dining table 216
Propane compartment wrapped in Reflectix. The linoleum floor is so hideous/blemished that I actually like it. Covered up with carpet so as not to implicate the guilty/lazy 217
Passenger side where the 2 drawers go. Wiring from the Commode area where the Diesel Heater and Electrical outlet will be fed along with hydraulics and water tank drainage line secured for installation of drawers 217
I used a single sheet of plywood from the Refrigerator to the Cab Over, routed the edges out and then used brass screws to secure the paneling (all covered in blue painters tape). Adding the painters tape was a mistake as there was some transfer of adhesive which darkened the wood somewhat 218
Another angle 219
2.7mm plywood - Cheap but a bit fragile (Home Depot approximately $18 a sheet however the Pandemic interrupted stock availability and pattern continuity) 220
Another angle 221
Another angle 222
Original plastic front drawers 223
Original plastic front drawers 224
Original plastic front drawers 225
Original front drawer space 226
Original front drawer space 227
Original front drawer space 228
Space cleaned up and ready for new self closing drawers 229
Sliding drawers replaced the plastic insert drawers to maximize depth 230
Space cleaned up and ready for new self closing drawers 231
Space cleaned up and ready for new self closing drawers 232
Space cleaned up and ready for new self closing drawers 04. Waiting for version 2 of the counter top after deciding to replace the stove with a 2 burner unit 233
Current counter top configuration including food storage and Inverter/MPPT space now that the original oven has been replaced by the 2 burner stove top. Laminate was sourced from Home Depot 234
Cabinet outer paneling 235
Cabinet inner paneling 236
I basically ended up using the frame pieces and added my paneling to both the exterior and interior sides of every drawer, door and surface secured by brass screws.