Overhead Cabinets and Ceiling and Roof

A/C wiring (blue) and 110v ceiling receptacle between A/C and rear of cab (yellow). Receptacle is for running a extension cable out the back for whatever 057

A/C wiring (blue) and 110v ceiling receptacle between A/C and rear of cab (yellow). Receptacle is for running a extension cable out the back for whatever 057

Forming of upper cabinet concept 058

Forming of upper cabinet concept 058

Added some LED lights with a controller in the upper cabinet area 059

Added some LED lights with a controller in the upper cabinet area 059

Added some LED lights with a controller 060

Added some LED lights with a controller 060

Added cross bracing support for the 4 Solar panels and cut/taped 3/4" R7 insulation for the entire ceiling area 061

Added cross bracing support for the 4 Solar panels and cut/taped 3/4" R7 insulation for the entire ceiling area 061

Added cross bracing support for the 4 Solar panels and cut/taped 3/4" R7 insulation for the entire ceiling area 062

Added cross bracing support for the 4 Solar panels and cut/taped 3/4" R7 insulation for the entire ceiling area 062

Mounted the IOTA charger and Progressive power conditioner on the 2"x2" longitudinal pieces 063

Mounted the IOTA charger and Progressive power conditioner on the 2"x2" longitudinal pieces 063

Wiring below the insulation before overhead paneling goes in 064

Wiring below the insulation before overhead paneling goes in 064

Wiring below the insulation before overhead paneling goes in - rough in of overhead lighting in the Cab Over area 065

Wiring below the insulation before overhead paneling goes in - rough in of overhead lighting in the Cab Over area 065

Tape, Tape and more Tape. I used over 65 different pieces of R7 insulation for all the overhead spaces 066

Tape, Tape and more Tape. I used over 65 different pieces of R7 insulation for all the overhead spaces 066

Added Reflectix horizontally under the roof skin and taped as a barrier before installing/taping all the R7 insulation 067

Added Reflectix horizontally under the roof skin and taped as a barrier before installing/taping all the R7 insulation 067

2 items on left are inserts for the Starlink extended pipe mount. 3 items on the right are the Anderson connector mounting plates 068

2 items on left are inserts for the Starlink extended pipe mount. 3 items on the right are the Anderson connector mounting plates 068

3D printed STL file I used 069

3D printed STL file I used 069

Custom aluminum plate holds the Anderson connector mounting brackets in the cabinet space above 070

Custom aluminum plate holds the Anderson connector mounting brackets in the cabinet space above 070

Did my best to insulate and keep a moisture barrier to increase heating/cooling efforts. I had some draft stoppers made 8’ long x 2 1/2” diameter and filled with Cotton/Buckwheat Hulls to place on top of the Pirelli seal spot between the upper/lower sections as an added barrier for dust/critters.