Plumbing and Water Pump
Water pump area cleaned up - External water source and drainage hole in the middle of the picture 339
Water pump area different angle 340
Sinks with sound deadener applied 341
Water pump and accumulator installed on rubber vibration bushings and floor fiber glassed 342
A different angle 343
A different angle 344
Started installing pex to/from the water tank. I placed 1" pvc into all the holes in the floor so in the event of a leak (if I'm lucky) I could prevent water going down into the battery/circuit breaker area directly below 345
Added the 90 degree bends to keep the Pex in place 346
A different angle 347
A lot going on in this space. Upper valve handle when pointing to 3:00 o'clock allows the water pump to feed the faucet from the water tank. Bottom valve hand when pointing to 3"00 o'clock allows water from outside to fill the water tank 348
A different angle 349
A different angle 350
A different angle 351
A different angle 352
I used 1/2” pex but apparently you can use 3/8” and it’s a lot easier to work with.
In the picture “A different angle 351” you can clearly see the ON / OFF text on the valve handle.
A check valve is installed on the water hook up line.